![]() ![]() 29/64 drill bit for pull lock installation.9/32 drill bit for threaded stud installation.Tools needed for WiseCable ® WiseRail ® Heritage WC-HS Series on level straight runs: If turning 90⁰, a 2-step turn using aĭouble corner post configuration is required as illustrated in the corner post instructions ( view here). ![]() When taking the WiseCable ® WiseRail ® Heritage WC-HS Series cable railing through a corner, do not bend the cable past 45⁰ at any one time. This is both the most economical solution and where the fittings are least visible. Meaning you can use a through-the-post configuration. Use the WiseCable ® WiseRail ® Heritage WC-HS Series for decks with dedicated end posts for each run where the posts are situated such that, the back sides of the posts are all accessible. A brass hex nut and some metal thread willĮxtend beyond the back of the post on one end. WiseCable ® WiseRail ® Estate WC-ES Series, but the threaded studs are a basic, functional fitting, not a hide-in-the-post solution. These threaded stud kits are more economical than the This through-the-post configuration is the only scenario in which the economical threaded stud kits may be used. Tools needed for WiseCable ® WiseRail ® Estate WC-ES Series on a pitch or stairs: The tube will prevent the cable from carving a groove into your post where it exits at an angle. Go up a stair and across a landing by inserting post protector tubes in the break-over post. The WiseCable ® WiseRail ® Estate WC-ES Series can be used to A pull lock fitting is installed through the other end with a post protector tube, ordered separately. The tensioning device is a 3½” long Invisible receiver, which installs through Only intermediate posts need to be drilled on the angle of the stairs.įor wood posts on a pitch or stairs, install the WiseCable ® WiseRail ® Estate WC-ES Series the same as on straight runs. Use the WiseCable ® WiseRail ® Estate WC-ES Seriesįor any type of wood post as an outside to outside fitting on any pitch or stair run. The cleanest approach to running cable on a pitch is to drill through both end both posts on the square (NOT at the angle of the stairs). ![]() Installation Guide Installation Accessories
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |